NIKAWA 118 Epoxy Adhesive Set (Part A & Part B)/ AB Glue Epoxy/ AB Gam
Brand NIKAWA 118
Size (L x W x H) 15 cm x 15 cm x 20 cm
Availability In Stock
Shipping Fee
Malaysia Not Applicable
Size
Quantity
Description

2 Sizes Available:-

i) 0.5kg Set - Part A (340g) + Part B (160g)

ii) 1kg Set - Part A (680g) + Part B (320g)

 

NIKAWA 118 is a high performance tow component epoxy adhesive. Due to its good adhesion strength, it can use to bond, seal and fill to a wide range of similar or dissimilar material such as wood, metal, concrete, fiberglass, glass, ceramic, marble, some plastic and etc. It also has high mechanical strength and thermal resistance as well as resistance to numerous chemicals and a range of climatic conditions. These superior performance characteristics have gained wide acceptance as materials of choice for a multitude of structural application and protective coatings.

Nikawa118 is Specially formulated for boat building,woodworking and construction industries.it has high mechanical strenghth,thermal resistance to numerous chemical.It is excellent for bonding wood,ceramic ,glass and other surface

Nikawa118专为船舶建造,木工和建筑行业而设计。具有高机械强度,耐多种化学品的耐热性。非常适合粘接木材,陶瓷,玻璃和其他表面

NIKAWA 118 cure at room temperature after mixing the resin with hardener. Heating can considerably shorten the setting time. It cure without releasing moisture, solvent or other by products, so that it is 100% solid and consequently shrinkage stresses are minimized, resulting in a stronger and more durable bond.

 

Technical Data:
Part A Epoxy Binder (white Colour)
Part B Hardener (Amber Colour)
Viscosity Paste
Mix Ratio A:B (By Volume) 2:1
Pot Life (TECAM) 250gm @ 20°C 30 minutes
Cure Time @ 20-25°C 24 hours
Specific Gravity 1.1 - 1.2 g/cm³

 

Application Data:
i. Clean the substrate surface to ensure free from all contaminants
ii. Mix 2 part resin A and 1 part hardener B until even colour is achieved.
iii. Use a putty knife to apply the mixture onto the clean surface substrates.
iv. If use for coating, the best wetting time for the mixture is within 15 minutes.
v. The cure surface can be sanded after three hours but through cure is 24 hours.
vi. The equipments can be cleaned with xylene. thinner or nikawa solvent before the mixture is cure.
Note: Do not mix exceed at a time as the pot life will be shortened, caused by generation of exotherm.